Calliesmom
Moderator
if it's supposed to be Spitfire, the one on the right
but I really like the one on the left
but I really like the one on the left
3D Sheltie model
- Thread starter SheepOfBlue
- Start date
SheepOfBlue
Premium Member
Closer to a mahogany like Callie was.if it's supposed to be Spitfire, the one on the right
but I really like the one on the left
RikyR
Premium Member
Left one for me,
Sharon7
Moderator
I like them both but the one on the right you can see his face better.
Ron Atkinson
Premium Member
I think that they are both very good. I like the one on the right the best. 
SheepOfBlue
Premium Member
Started a Sca. I was shocked on how much time it is predicted. Though I added a lot of detail to his face. I did the brown/black rings around his eyes. I added brown to his muzzle. Of course his white blaze but also his freckles and black/brown to the nose. I suspect at least one failure 
SheepOfBlue
Premium Member
EPIC failure So for some reason the supports were horrid. I stopped it because of that then found out why the print was over two days. someone had a really bad setting for the nozzle. The ones on the machine are 0.4mm and I had 0.2mm settings. So in plainer language half the actual size not only increases print time but all the flow is wrong. So it would take longer to incorrectly print. Learn from your mistakes Now the predicted print time is 7 hours vs over 50.
So for some reason the supports were horrid. I stopped it because of that then found out why the print was over two days. someone had a really bad setting for the nozzle. The ones on the machine are 0.4mm and I had 0.2mm settings. So in plainer language half the actual size not only increases print time but all the flow is wrong. So it would take longer to incorrectly print. Learn from your mistakes Now the predicted print time is 7 hours vs over 50.