Tomorrow my groomer and I are gluing Callan's ears. I finally decided to go ahead as his ears ars are starting to fly (he is 4 months today). Of course, now that I decided, his ears are tipping nicely today, thank you!go figure!
Anyway, I'm torn between several techniques.
1) Ann's technique where you brush up the fur in front of the ear and put the glue on the outside tip of the ear so that you are gluing the ear behind that tuft of hair
2). The opposite, where you glue on the inside tip of the ear and put the ear tip over the tuft of hair rather than behind.
And do you brace between the ears first or after tipping?
And then finally, I was reading today about simply weighing the ears with speed sew and tungsten powder. What are thoughts about that. I recognize that wont correct the set between the ears but sure seems easier!
Ps. My first Sheltie was when I was 8 years old. The breeder recommended putting chewing gum on the tips! Now that's easy! Anybody doing that anymore?
Always glue to the inside of that tuft of hair.I used to roll my finger,and it would attach very nicely. Then take the hair and brush forward after gluing. It helps bring that topline of the skull forward,and looking at the pup after it is all done,the pup will look like he has a nice rounded edge. Hard to explain,but always glue to the inside.
If you need a bridge done,look closely after the ears are glued. On the inside edge of each ear,near the skull,you will see wisps of hair growing.Take only a dab of glue,bring ears up close,and roll some glue to that wispy hair,rolling it between your fingers. Wait till it is dry,before you let pup off table.
I have seen videos,where breeders will create that bridge first,bringing the sides of ears together,once dried,then they would roll the year over at the correct breaking point,and glue down to inside edge of ear. (so tip to inside edge of ear,using that tuft of hair).
go figure! 

Were his ears as far apart as Baker's before they were glued/braced?